> Today, I found that the hole 2 draw is > DEAD! There is no tone whatsoever, just air. When I draw very hard, it > makes a sound like someone shoved a wet rag into a saxophone. > something that I should look for on the reed itself to help diagnose the > problem? Or should I just contact Kevin's and see what they or Hohner will do? >
I have found on all bar my LO that the 2 draw is always a little dodgy (though I have never had one fail from new). I would try adjusting the offset (Check the archives) or, first, just draw and blow rapidly on the 2 hole quite hard. Whilst adjusting the offset, it might be worth just prodding the reed about a bit to check that it is poperly alligned or that it is not blocked. In terms of alignment, I have had a few reeds that have twisted slightly from the rivet point so that one edge was catching on the reed slot. I used the blade on my trusty old pen knife to tap it back across. It could be a hundred and one things stopping it from vibrating properly but logic suggests that, if you can get a slight noise by drawing hard, then all is not lost. A bit of prodding normaly does the trick though.